Some final adjustments

Today we worked on the Chevelle, trying to get it ready for paint next week. It is so close to being finished I can taste it.

The first couple of pictures show us sanding the primer used to cover the blocking marks created during the smoothing of the body. We are sanding with a 320 git paper, which is quite fine, on this final sand before the car goes into the booth for paint.

During our test fitting of the fenders, door, hood and trunk we uncovered a little problem. While all the fitting and adjusting had already been performed in the Murphy Rod & Custom shop, the car was on a buck. A buck is a shorthand term for the custom frame Kelly constructed so the body could easily be moved around his shop while the chassis was at the owners house having the drive train installed.

On March 3oth we mated the body to the chassis, and it was a real struggle. So much so, apparently, that once everything was attached and tightened down, it tweaked the car just enough to caused the trunk lid to kiss the right side quarter panel. Now I like kissing as much as the next guy, but not on my cars, so I called Kelly Murphy of Murphy Rod & Custom to see what we needed to do.

In the third picture you can see Kelly looking over the gaps. He determined, as I had, there was no way to adjust the trunk lid to fit. Moving the lid left, to open the gap on the right, would simply move the problem to the left side of the car. Time to bring out the big guns.

The fourth photo is of Kelly grinding away on the edge of the trunk lid, removing the metal a tiny fraction of an inch at a time. He would run the grinder over the edge of the lid a time or two, close the lid to check the fit, and then do it all over again. Once he was satisfied with the fit, the edge was welded to preserve the integrity of the edge.

You can see the final result in the last photo … a nice straight even gap down the entire edge without a touch in sight. Obviously this wrecked the primer that has so carefully been applied and sanded in this area. That is why this step is done before all the priming starts, so these kinds of heavy duty “adjustments” don’t cause rework. But that chassis to body wrestling match caused unexpected problems that had to be addressed after the fact. Oh well, it is only a minor setback, easily rectified.

Next week we will prime and sand this area again, before we put the car in the booth, and the post primer “adjustment” will be completely undetectable. In fact, I have already forgotten it even happened.

Posted on April 27, 2012, in 1965 Chevrolet Chevelle and tagged , . Bookmark the permalink. Leave a comment.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: