Daily Archives: June 30, 2017

FJ

DSCF0180DSCF0184DSCF0183DSCF0182DSCF0181Back in the mix is the FJ 55. We have been a little slow over the past few months on our restoration work since Paul was out with a shoulder surgery but now we are back full force. Paul is back and we have also hired an old friend, Jordan. He picked right up where we stopped.  The tail gate had had a few places welded up but not quite finished up. Jordan jumped right in and got to work. The tail gate is now ready for primer as well as the left rear door. He also spent some time cleaning up the drip rails and blocked out the rest of primer on the rest of the vehicle. Next week we will get these final repair spots in primer then start prepping the jambs for paint.

Advertisements

Yo Holmes, to Bel-Air

DSCF0124DSCF0125DSCF0126DSCF0123DSCF0148DSCF0155DSCF0194DSCF0189DSCF0193DSCF0196DSCF0186DSCF0198DSCF0199DSCF0201DSCF0207DSCF0206DSCF0205DSCF0209DSCF0210DSCF0212DSCF0208DSCF0124DSCF0125DSCF0126DSCF0123DSCF0155DSCF0148DSCF0194DSCF0189DSCF0186DSCF0191DSCF0193DSCF0196DSCF0198DSCF0199DSCF0201DSCF0205DSCF0206DSCF0207DSCF0209DSCF0210DSCF0211DSCF0212DSCF0208Here we have a beautiful 1957 Chevy Bel-Air in the shop to get a new lease on life. We started by disassembling the front end and sending all of the parts out for stripping. Once back from the blasters, Jordan got to work sanding all of the parts prepping them for primer. Since this is an extremely important step, extra time was taken to be sure the metal was as clean as possible. Today we hung up all the parts and prepped them for PPG’s DP epoxy primer and applied 2 good coats. Next step will be to perform any metal work that needs to be done and start straightening the panels. The inner panels and fresh air vents will be prepped for paint since they wont really need any body work. Stay tuned.

%d bloggers like this: