Daily Archives: July 24, 2018

Wires everywhere!

DSCF1130DSCF1140DSCF1139DSCF1137DSCF1131Still plugging along on the VW. The wiring is coming along nicely. All of the major wires are run and most things are hooked up. We are waiting on some parts that is keeping us from finishing that up so we are installing what we can to keep things moving.  Once we get the speedometer and the steering column installed that mess of wires will be cleaned up a little. We secured the wiring back at the firewall and started installing the insulation back there. VW made little flexible hooks for the wiring to run through when these were new but the aftermarket parts don’t put them on the ones made today. This firewall was replaced at some point a while back so we had to add the clips to hold the wiring. We are making good progress each day. This little VW will be back on the road before you know it.

Advertisements

Fender bender

DSCF1132DSCF1133DSCF1135DSCF1136Jordan has been devoting the past few days to the C10 project. He has the body work on the doors pretty well wrapped up and today started on the fenders. Here again these are new parts but not without issues. The owner wanted to do fill in the turn signal holes that were in the fenders to match the way the quarters were done. This cleans up the look of the truck. It makes the sides look smoother. When that was done, they left the inner lip where the light use to mount and it didn’t look good. Although it will be hard to see and most people would never notice it, we would. So the first part of the day was spent grinding away all the metal that wasn’t needed on the back side of the fenders. He then started blocking out the front side to bring the high and low spots out. Once those were found he started straightening.  A hammer and dolly were uses to minimize the amount of filler. It looks like a little too much heat got to the panel when the patches over the signal holes were filled because the fenders were a little warped around the area where the lights use to be. Its hard not to get any warping when welding sheet metal because today’s metal is so thin. This is why there is just a large patch at the fronts of the fenders.  He should have these finished up tomorrow and the goal will be to get these and the doors in their first coats of primer by Thursday.

C10 in progress

DSCF1081DSCF1081DSCF1085DSCF1127DSCF1126DSCF1125DSCF1129Over the past couple of weeks we have been plugging along on the C10 project. Repairs on the cab are moving along. The firewall is pretty smooth, work on the cab continues and work on the doors has begun. Although these are new doors they still came with a few dents that needed attention. We blocked them out to find the low spots and high spots then straightened them out. We will be applying our high build primer over these doors in the next day or so and they will receive another blocking followed by a final prime with regular urethane primer. Once that happens we will have 2 more panels ready for paint.

%d bloggers like this: