Daily Archives: August 20, 2018

C-10 body work continues

DSCF1279DSCF1271DSCF1270DSCF1265The progress continues on the C-10. We are working hard to make sure the body work on the cab is as nice as the rest of the panels we have ready to paint. The cab needs pretty extensive body work but each day we get a little closer.

Advertisements

No junk in this trunk

DSCF1276DSCF1277DSCF1278 The ’57 got a trunk today. We installed the rubber on this and the doors last week and today we were able to get the trunk installed. Tomorrow a door goes on and the last door hinge should get painted. We had to send that hinge over to our buddy Kelly to get it repaired. One of the decorative covers was bent up pretty badly and he worked his magic on it and was able to save it.

Finally fenders

DSCF1267DSCF1266DSCF1274DSCF1281DSCF1282DSCF1285DSCF1284DSCF1283DSCF1272DSCF1273Paul was back on the bug today. Last week he stripped off the e-coat and primed the fenders. The next day he blocked that primer out and fixed a few dents. The next day he primed the parts once more and then had time to prep the bottom side for epoxy and bed liner. Those steps were completed last Friday. So today he blocked them out one last time and prepped them for paint. He did have enough time to get them painted today as well. Lots can get done when things go smoothly and here is a fine example. These came out really nice. Tomorrow we will hang the fenders on the body but they wont quite be ready to fully bolt on. We are still waiting on a few rubber parts to come in. The fender beading is one of them.

Seal installation

DSCF1248DSCF1249DSCF1250DSCF1251DSCF1252DSCF1253DSCF1254DSCF1255DSCF1248DSCF1249DSCF1250DSCF1251DSCF1252DSCF1253DSCF1254DSCF1255 Now that all of the sanding, buffing and polishing is complete, lets start putting this beauty back together. We like to start with the seals. Its much easier to install these while the parts are off and you can get around them. They also aid when lining up the panels. If you align the panels without the gaskets, you may have to adjust them again when you do install them. No since in doing it twice. We ordered our parts from Danchuk. These rubbers are very nice. They fit very well and come in bags labeled for where it goes. As you can see they look great as well. Goals for this week are to start hanging parts and getting them operational. That means the latches and mechanisms that make these parts functional will all be cleaned inspected and lubed up for installation. Stay tuned.

%d bloggers like this: