Here we have the fenders finished up and ready for paint. Jordan spent a few hours of the past couple of weeks working on these fenders and while he was working on the FJ, I got a chance to finish them up. As you can see they are in great shape and just needed a little body work to make the straight. Once I fine tuned where Jordan left off, we wiped them down several times and set them up in the booth. We sprayed a full coat of PPG DPLV then followed that up with PPG’s urethane primer. 4 coats later and a little dry time and they are straight and ready for the final blocking before getting painted.
We have been plugging right along on the ’57 in between the FJ and the collision work this week. Paul painted a whole slew of brackets and the radiator support. Jordan was busy disassembling the dash, tagging and bagging all of the parts that go behind it. For an old car, this thing is really pretty complicated. Lots of time was taken to make sure nothing gets broken, bent or lost. I believe that we have done a pretty decent job with that but it does take extra time. Hopefully all the documentation will make it somewhat easier when it comes time to put it all back together. There are cables, brackets, wires, levers, pulleys and all sorts of other things behind that dash. I did some finishing work on the fenders that Jordan started on last week. Those should be ready for the first round of primer next week.
We have been keeping the progress moving on the ’57 over the past week. We have got a good jump on the body work for the fenders as well as painting the fresh air tubes. These parts were sprayed with epoxy a couple of weeks ago and have been sanded back down, sealed and sprayed with an egg shell urethane paint. These parts are now ready to be stored until they go back on the car. The fenders have a few dents from over the years that have to be repaired before paint. Here you can see that has begun. We will continue to work the fenders until all the dents are out. Once that is achieved, the will be primed again with a urethane primer. We may do this several times to be sure we are able to block out any waves or slight imperfections in the metal. This will ensure a completely flat, straight panel for the best possible paint job.
Yesterday Jordan spent a good portion of the day breaking down the doors. Today, he has been at it pretty steady all day. The doors are both completely apart and removed, the trunk is off and apart, the hood moldings have been removed as well, as a few more interior molding parts. The time consuming part of all this is bagging and tagging all of the parts and their bolts to make reassembly much easier. And buddy I’ll tell ya, their are a lot little parts. We have tubs that we use to store parts in so that things remain in one spot for safe keeping. Inside the tubs are bags with screws, bolts and clips labeled where they came from as well as the tons of bright work from the same panels. Hopefully tomorrow these newly disassembled parts will be going to the blaster.
Here we have a beautiful 1957 Chevy Bel-Air in the shop to get a new lease on life. We started by disassembling the front end and sending all of the parts out for stripping. Once back from the blasters, Jordan got to work sanding all of the parts prepping them for primer. Since this is an extremely important step, extra time was taken to be sure the metal was as clean as possible. Today we hung up all the parts and prepped them for PPG’s DP epoxy primer and applied 2 good coats. Next step will be to perform any metal work that needs to be done and start straightening the panels. The inner panels and fresh air vents will be prepped for paint since they wont really need any body work. Stay tuned.