Posted by Jonathan
We finally have the Juke back from the frame shop. While it was there they performed a light pull on the rear body panel, then replaced it. You can see Chris prepping the panel for seam sealer and etching primer. We use an etching primer to bite into the metal and provide good adhesion of the seam sealers. Seam sealer is used to fill in the tiny gaps where metal is over lapped to keep water and wind out. Tomorrow we will put this in the booth and paint that panel, then start the reassembly process. If all goes well, we hope to have this Juke back home on Friday. Just in time for a nice weekend.